TI Terracotta is an extrude twin skinned clay terracotta panel available in two standard thicknesses, 17mm & 22mm, for flat panels.
The 17mm thick panel is stocked in a selection of standard colours 1200mm x 400mm up to 3000m2 per colour. It is also available in a height of 300mm for new productions.
The 22mm thick panel comes in a variety of heights ranging from 200mm – 600mm with a larger range of colours and finishes based on new productions.
Clips – Small retaining clips approx. 20mm wide are fixed directly back to the T/L rails of the subframe at either side of the panel. The clips come with an anti rattle gasket set into an extrusion to stop any movement of the panels when on the wall.
The system is best ‘brick built’ meaning an installation bottom to top will most likely need to be undertaken.
Horizontal Profile – This fixing method provides continuous support along the top and bottom edges of all panels. This is used for landscape orientation only*.
Supplied in 6m lengths, the profile can be fixed back to vertical centres of 600mm allowing the system to be gridded out ahead of the panels arrival to site.
Each panel is retained along the top and bottom edges of the panel and a small bead of silicone is utilised to stop any movement. The silicone is normally applied in the centre top of the panel between the rail and panel.